Leo Jaymz DIY Electric Bass Guitar Kits - Mahogany Body, Roasted Maple Neck and Ebony Fingerboard - Fully Components Included (AX Bass)
- Bolt-on Neck 4-String DIY Electric Bass Guitar Kit
- EX style roasted mahogany body and drilled cavities
- Roasted maple neck, composite ebony fretboard
- Shaped headstock, with four holes for machine heads
- 20 frets and triangle inlay on the fretboard
- Bright Chrome color controls and hardware
- All necessary hardware, components and wires are included
- The thickened single side can be pasted with copper foil paper, and the noise can be effectively reduced by pasting at the positions such as the wire tray and pickup groove.
- All wires are pluggable, eliminating the hassles of welding.
ByJohn HayterTuesday, 31 August 2021
Looks great. Wood is not sanded to a point where you can apply the finish. You must sand the wood in order to apply the finish with a good 320 grit or smaller. The instructions are the worst I have ever seen. The project cannot be assembled unless you have extensive knowledge of the internal workings of a bass guitar. A resistor (I think) is included but not shown on the wiring diagram! Where does it go? No one knows! There is no help with the wiring. Assembly of the project is very if-fy and incomplete.
You're buying an unfinished DIY kit bucko, do you expect it to be finished when you buy it?
my message below yourse, now im under youre skin! fuck you!
hey! john is raises some valid points
okay boomer 😂😂😂😂
Similar products
Your cart is currently empty.